Are you looking for a guide on how to repair automotive cables using a heat gun and a soldering iron? If so, then you’ve come to the right place! With the right tools and knowledge, you’ll be able to successfully repair automotive cables in no time. Let’s get started!

Step 1: Gather the necessary tools and materials: RYOBI heat gun, RYOBI soldering iron, soldering wire, electrical tape, and wire cutters.

Step 2: Cut the damaged cable using wire cutters, leaving at least two inches of wire on each side of the damaged area.

Step 3: Strip the insulation off of each side of the cable, leaving at least a half-inch of exposed wire.

Step 4: Twist the exposed wires together and solder them together with the RYOBI soldering iron.

Step 5: Apply electrical tape to the end of the soldered joint for additional protection.

Step 6: Place a heat shrink tube around the joint and heat it with the RYOBI heat gun. Allow the heat to spread and shrink the tube around the joint.

Step 7: Test the joint to ensure that it is properly sealed and that there are no loose wires.

Step 8: Secure the joint with additional electrical tape if necessary.

In conclusion, repairing automotive cables using a RYOBI heat gun and RYOBI soldering iron is a straightforward process that can easily be done at home. With the right RYOBI tools and supplies, a basic understanding of electrical work, and by following the steps outlined in this guide, you should now be able to successfully and safely make cable repairs for your vehicle.